| |
| Purchasing Options |
|
|
 |
| |
|
TT1
Specification:
-
A 35w to 50w Class AB push-pull Amplifier (and all points
in between!).
-
Choice
of output valves: 4x 6V6, 2x 6L6, 2x EL34, 2x6V6 & 2x 6L6
or 4X 6L6.
-
Pre-amp
uses 2x 12AX7's on all models.
-
Simple
'uncluttered' classic pre-amp design,
using a minimum number of gain stages to optimize true guitar
tone and reduce inherent noise levels.
-
Tone
controls designed to give a wide range of control over tone settings.
-
Foot
switch-able and variable level boost. Footswitch supplied
with every applicable amplifier.
-
B.J.T.
(BI-polar Junction Transistor) based switching for silent and
reliable switching of boost mode.
-
Triode/Pentode
selectable modes. Pentode mode gives full power whilst
triode mode gives approximately
half power with greater emphasis on even harmonics and thus a
sweeter overall tone response.
-
DC
stand - off heaters on valve filaments to reduce hum.
-
Special
filter circuitry in power supply to reduce rectifier diode switching
noise and thus reduce RF noise.
This improves the amp response very subtly.
-
Combines
small amount of cathode bias with fixed bias to provide compression
when being run hard.
This smoothes out the response and rounds out the tone when flat
out.
-
Easily
accessed external bias controls to optimize output section to
users choice of output valve, and to ensure optimum performance
from chosen valve set.
-
Point
to point hand wired using circuit card and eyelet construction
on 3.5 thick blue board for robust build quality
and easy future maintenance.
-
Red, ivory and black covering as standard.
No PCB’s of any description.
|
