|
| |
| Purchasing Options |
|
|
 |
| |
|
TT2, TTSpecial, TTSpecial+
Specification:
-
An 18
Watt Class A to 35 Watt Class AB push-pull Amplifier (and all points
in between!).
-
Sheldon EL84 or EL34 tubes as standard.
-
Pre-amp
uses 2x 12AX7's on all models.
-
Simple
'uncluttered' classic pre-amp design,
using a minimum number of gain stages to optimize true guitar
tone and reduce inherent noise levels.
-
Tone
controls designed to give a wide range of control over tone settings.
-
DC
stand - off heaters on valve filaments to reduce hum.
-
Special
filter circuitry in the power supply to reduce rectifier diode switching
noise and thus reduce RF noise.
This improves the amp response very subtly.
-
Combines
a
small amount of cathode bias with a fixed bias to provide compression
when being run hard.
This smoothes out the response and rounds out the tone when flat
out.
-
Easily
accessible external bias controls optimize output section to
accommodate the
user's choice of output valve, and to ensure optimum performance
from the chosen valve set.
-
Point
to point hand wired using circuit card and eyelet construction
on 3.5 thick blue board for robust build quality
and easy future maintenance.
-
Red,
ivory and black covering as standard.
No PCB’s of any description.
|
