Options:
|
TTJunior, TT3, TT3R Specification:
- 1 Watt Class A to 9W Class AB push-pull Amplifiers (and all points in between!).
- Sheldon 12AU7, 12AT7 and 12BH7 output tubes available as standard
- Pre-amp uses 12AX7's on all models.
- Simple 'uncluttered' classic pre-amp design, using a minimum number of gain stages to optimize true guitar tone and reduce inherent noise levels.
- Tone controls designed to give a wide range of control over tone settings.
- DC stand - off heaters on valve filaments to reduce hum.
- Special filter circuitry in power supply to reduce rectifier diode switching noise and thus reduce RF noise. This improves the amp response very subtly.
- Combines small amount of cathode bias with fixed bias to provide compression when being run hard. This smoothes out the response and rounds out the tone when flat out.
- Point to point hand wired using circuit card and eyelet construction on 3.5 thick blue board for robust build quality and easy future maintenance.
- Red, Ivory and Black covering as standard.
No PCB’s of any description.
|
